30
THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO APPLANIX CORPORATION. RELEASE TO THIRD PARTIES OF THIS PUBLICATION OR OF
INFORMATION CONTAINED HEREIN IS PROHIBITED WITHOUT THE PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION. APPLANIX RESERVES THE
RIGHT TO CHANGE THE SPECIFICATIONS AND INFORMATION IN THIS DOCUMENT WITHOUT NOTICE. A RECORD OF THE CHANGES MADE TO THIS
DOCUMENT IS CONTAINED IN THE REVISION HISTORY SHEET. COPYRIGHT © APPLANIX CORPORATION, 2021ALL RIGHTS RESERVED. NO PART OF
THIS PUBLICATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS WITHOUT THE
PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION.
Figure 30: Receiver Reset
4.6.4. General Configuration:
The General Configuration window includes settings of the discrete I/O signals:
Input signals Event 1 and 2.
Output 1 PPS signal.
It is recommended to have all signals enabled.
The event slope indicates the active edge of the input event signal that will be registered
and time tagged by LVX.
The event navigation shift is the time, positive or negative, by which the registered event
time is adjusted before interpolating the navigation solution for the event triggered
navigation outputs (NMEA and GSOF). This time shift does not affect the time of the
regular event outputs or logging.
Figure 31: General Configuration
To Next Page
Loading...