DRAFT
September 25, 2007 1:07 am, 4376782_Colocated_Installation.fm
Chapter 3 Install the Colocated Layout
Perform the RNase P Experiment
Applied Biosystems StepOne
™
and StepOnePlus
™
Real-Time PCR Systems
Installation, Networking, and Maintenance Guide
46
Notes
Unload the
Instrument
PHYSICAL INJURY HAZARD. During instrument operation, the
temperature of the sample block(s) can exceed 100 ° C. If the instrument has been used
recently, keep your hands away until the sample block(s) reach room temperature.
IMPORTANT! Wear powder-free gloves when you handle the
RNase P plate
.
1. Open the instrument drawer.
2. Remove the RNase P plate from the sample block(s).
3. Close the instrument drawer carefully.
4. Dispose of the RNase P plate.
IMPORTANT! Do not power off the instrument following a run. The instrument
automatically enters a hibernation mode when not in use. Power off the instrument
only when it will not be used for an extended period.
To Next Page
Loading...
