Applied Biosystems StepOnePlus - Transfer the Experiment

DRAFT September 25, 2007 1:07 am, 4376782_Standalone_Installation.fm
Chapter 4 Install the Standalone Layout
Analyze the RNase P Experiment
Applied Biosystems StepOne
™
and StepOnePlus
™
Real-Time PCR Systems
Installation, Networking, and Maintenance Guide
66
Notes
Transfer the Experiment
After unloading the instrument, transfer the experiment data to the computer for analysis.
Transfer the Data
to the USB Drive
1. Connect a USB drive to the USB port.
2. In the RNase P Wizard, touch .
If the StepOne
™
instrument cannot find the USB drive, touch OK, wait for 30 sec,
then touch Collect Results again.
3. When prompted that the data has been transferred successfully, touch OK, then
touch .
4. Remove the USB drive from the instrument.