EasyManuals Logo

Applied Biosystems StepOnePlus User Manual

Applied Biosystems StepOnePlus
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
DRAFT
September 25, 2007 1:07 am, 4376782_Standalone_Installation.fm
Chapter 4 Install the Standalone Layout
Set Up the Computer
Applied Biosystems StepOne
and StepOnePlus
Real-Time PCR Systems
Installation, Networking, and Maintenance Guide
52
Notes
Install the Computer
After obtaining the required materials, unpack the computer.
Confirm the Site
Requirements
Confirm that the installation site meets the physical and environmental requirements for
the computer. See the documentation for your computer for the site requirements.
Place the
Computer
PHYSICAL INJURY HAZARD. Improper lifting can cause painful
and sometimes permanent back injury. Use proper lifting technique when lifting or
moving the computer. We recommend safety training for proper lifting techniques. Do
not attempt to lift or move the computer or the monitor without the assistance of others.
Depending on the weight of the computer, this may require two or more people.
1. If you have not done so already, unpack the monitor, computer, keyboard, and
mouse, and assemble the computer components as described in the computer
installation guide.
Guidelines for lifting and moving the computer:
Make sure that you have a secure grip on the computer when lifting.
Make sure that the pathway from the beginning of the lift to the final location is
clear of obstructions.
Do not lift an object and twist your torso at the same time.
Keep your spine in a neutral position while lifting with your legs.
Coordinate lift and movement with all participants before lifting and carrying
the computer.
Instead of lifting the computer/monitor from the packing box, tilt the box on its
side, then slide the contents out of the box.
2. Make the following connections:
3. If you ordered a laptop computer from Applied Biosystems, install the PCMCIA
Network Card as described in the documentation accompanying the card.
After installing the PCMCIA network card, wait several minutes to allow the
computer to enable the device. The computer may require time to initialize the drivers
and register the network card with the operating system before it is available for use.
Connect Do Not Connect
Power Mouse Keyboard Monitor Ethernet
or
or or

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Applied Biosystems StepOnePlus and is the answer not in the manual?

Applied Biosystems StepOnePlus Specifications

General IconGeneral
BrandApplied Biosystems
ModelStepOnePlus
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals