20
After the 60 seconds of GPS Sync, the indicator will change to GPS
OK. In this condition truck mode is operational and it is also ready to pull from the
cradle and enter walk mode.
This indicator is displayed when the unit is pulled from the cradle when
entering walk mode. It will stay in this condition while out of the cradle.
GPS is not required when the Navigator is in Walk mode, and no QAM
channel has been selected in the active Detector Profile. In this case the GPS status
indicator will be blank.
Wi-Fi indicator
When the Navigator Plus is connected to a Wi-Fi hotspot, the Wi-Fi indicator
is illuminated. The does not indication connection with the server, just the hot spot.
Even during times where a wireless signal is not present, the Navigator will still remain
actively connected to the hotspot. If WiFi connection is lost the device will
continuously attempt to reconnect – let the device do its job in reconnecting before
attempting to troubleshoot.
Connection with Server
When the Navigator Plus establishes connection with the QAM Snare server
and data is being sent from the server to the device, the Server communication icon
will flash every second. A solid icon indicates no communication. If the device loses
connection it will continuously attempt to reconnect – let the device do its job in
reconnecting before attempting to troubleshoot.
Leakage detector Mode
To enter Leakage detector mode, select the “Modes” Hotkey and press the Enter
Button. The device will go through its connection sequence and connect to the Wi-Fi
network and then connect to the server – and then leakage detection will begin. In the
leakage detector mode, the Navigator Plus has the ability to simultaneously detect
leaks at three channels, one each within the aeronautic, the mid, and the LTE bands
To Next Page
Loading...
Need help?
General