35
your requested channels are in excess of the four currently being used. You should
change detector settings such that the listed frequencies are used, and then reconnect.
If only three channels are currently in use, the 4
th
frequency will show the word ‘any’
next to F4. If all four frequencies are currently allocated, the four frequencies will be
listed.
Closed buffer indication
When the device is buffering, and power is removed
from the device – a buffer closed indicator will appear
briefly in the form of a red X over the buffer box. It is
informational only.
Unable to connect to Q-browser
When connecting to Q-browser, the computer icon
must appear on the display. If it does not appear, try
pushing down on the detector to ensure it is fully seated
into the cradle.
GPS hold mode is over
Upon expiration of the 100 minute walk mode counter,
the following message will appear and the device will exit
the detector mode. To continue to use in QAM detector
mode the unit must be re-cradled. It may be used in Pilot
detector mode without re-cradling.
To Next Page
Loading...
Need help?
General