Subject to change · V 2.02.20 · EN
Page 59
www.argo-hytos.com
19. Decommissioning, disassembly, disposal
The OPCom particle monitor is a component which does not have to be taken out of operation. Therefore, this chapter does not
contain any information.
WARNING
Incorrect disassembly
If the particle monitor is disassembled incorrectly during pressurization, there is a risk of leakage of media under high pressure.
Be sure that all feed lines and the OPCom Particle Monitor are pressure-free.
Check the existing state.
Ensure that the machine is not turned on again.
Disassemble the OPCom Particle Monitor.
19.1 Environment
Dispose of the packaging material according to the local regulations.
Careless disposal of the OPCom Particle Monitor and the pressure fluid can cause environmental pollution.
Dispose of the OPCom Particle Monitor and the pressure fluid in accordance with the national regulations of your country.
Dispose of the pressure fluid residues in accordance with the applicable safety data sheets for these hydraulic fluids.
To Next Page
Loading...
