99
Cleaning the Vehicle
Frequent, thorough cleaning of your ATV will not only enhance its appearance but
will improve its general performance and extend the useful life of many components.
1. Before cleaning the ATV:
a. Block o the end of the exhaust pipe to prevent water entry. A plastic bag and
strong rubber band may be used.
b. Make sure the spark plug and all ller caps are properly installed.
2. If the engine case is excessively greasy, apply degreaser with a paintbrush. Do
not apply degreaser to wheel axles.
3. Rinse the dirt and degreaser o with a garden hose. Use only enough pressure
to do the job.
Prior to storing your ATV, it must be properly serviced to prevent rusting
and component deterioration.
CAUTION
• Wet brakes may have reduced stopping ability, increasing the chance of an
accident. Test the brakes after washing. Apply the brakes several times at
slow speeds to let friction dry out the components.
• Excessive water pressure may cause water seepage and deterioration of
wheel bearing, brakes, transmission seals and electrical devices. Many
expensive repair bills have resulted from improper high-pressure detergent
applications such as those available in coin-operated car washes.
WARNING
4. Once most of the dirt has been hosed o, wash all surfaces with warm water
and mild, detergent-type soap. An old toothbrush or bottle brush is handy for
hard to reach places.
5. Rinse the ATV o immediately with clean water and dry all surfaces with a
chamois, clean towel or soft absorbing cloth.
6. Clean the seat with vinyl upholstery cleaner to keep the cover pliable and glossy.
7. Automotive type wax may be applied to all painted and chrome plated surfaces.
Avoid combination cleaner-waxes. Many contain abrasives, which may mar the
paint or protective nish. When nished cleaning, start the engine and let it idle
for several minutes.
Preparation For Storage
SECTION 9
To Next Page
Loading...
Need help?
General
