64
Throttle Lever
Check to see that the throttle lever operates correctly. Throttle must open smoothly
and spring back to the idle position when released. Adjust as necessary for proper
operation.
Fittings and Fasteners
Always check chassis ttings and fasteners to ensure they are tight and secure.
Take the ATV to an authorized ARGO dealer or refer to the Service Manual for
correct torque specications.
Lights
Check the headlight, taillight and brakelight to ensure they are in proper operating
condition. Repair as necessary for proper operation.
Switches
Check the operation of the headlight switch, emergency stop switch and any other
switches. Repair as necessary for proper operation.
Tires
1. The tires listed below have been approved by ARGO for this model. Other tire
combinations are not recommended.
How to Measure Tire Pressure
Use the low-pressure tire gauge found in the tool kit.
NOTE: The low-pressure tire gauge is included as standard equipment. Make two
measurements of the tire pressure and use the second reading. Dust or dirt in the
gauge could cause the rst reading to be incorrect.
WARNING
POTENTIAL HAZARD
Operating this ATV with improper tires, or with improper or uneven tire pressure.
WHAT CAN HAPPEN
Use of improper tires on this ATV, or operation of this ATV with improper or uneven tire
pressure, may cause loss of control, increasing the risk of an accident.
HOW TO AVOID THE HAZARD
Follow the recommended tire pressures in the Operator’s Manual.
Operation - Before You Ride
To Next Page
Loading...
Need help?
General
