84
General Maintenance
Wheel Installation
NOTE: When reinstalling a wheel,
tighten the wheel nuts in a criss-cross
pattern. Be sure the tapered side of
the wheel nuts face the wheel rim.
1. Install the wheel and reinstall the
wheel nuts.
2. Tighten the wheel nuts in a criss-cross
pattern to 45 ft lb (61 N-m).
3. Remove the support stand and jack.
Front and Rear Wheel Nut Torque:
45 ft lb (61 N-m).
NOTE: The arrow mark on the tire
must point in the rotating direction of
the wheel.
(1) Wheel Nut
(2) Wheel Rim
Battery
The battery is located under the front hood panel of your ATV. After initial
service, batteries require regular cleaning and recharging in order to deliver peak
performance and maximum service life. Always read and follow instructions
provided with battery chargers and battery products.
NOTE: You can perform your own battery maintenance if you are qualied
to do so. If you do not feel qualied, take your ATV to an authorized ARGO
dealer for battery service. As with all other periodic maintenance, you are
responsible for any charges associated with these services.
WARNING
POTENTIAL HAZARD
Allowing open ames or sparks near the battery.
WHAT CAN HAPPEN
Gases may explode and possibly cause injury.
HOW TO AVOID THE HAZARD
Do not allow open ames or sparks near the battery.
NOTE:
• When the ATV is to be stored for an extended period, remove the battery
from the vehicle and charge it fully. Then store it in a cool, dry place. If the
battery is to be left on the vehicle, disconnect the negative cable from the
battery terminal.
• Battery posts, terminals and related accessories contain lead and lead
compounds. Wash hands after handling.
To Next Page
Loading...
Need help?
General
