Argo Xplorer XR 700 EPS 2023 User Manual

86
9. Test the battery voltage again after the battery has cooled. The meter should
read at least 12.5 Volts DC. If the voltage is as specied, the battery is ready
to be reinstalled into the battery compartment of the ATV.
NOTE: If the voltage in step 9 is below specications, charge the battery an
additional 1 - 5 hours and retest. If the voltage level is proper, then the battery
can be reinstalled into the battery compartment of the ATV.
General Maintenance
10. Reinstall the battery into the battery compartment of the ATV and apply a light
coat of dielectric grease on the battery posts and cable ends.
Before installing the battery, ensure the ATVs ignition switch is in the “OFF” position.
CAUTION
11. Connect the battery cables (positive (+) cable rst) and then the negative (-)
cable.
12. Reattach the battery hold-down.
Connecting the battery cables in reverse (positive (+) to negative (-) and negative (-)
to positive (+) can cause serious damage to the electrical system.
CAUTION
Charging / Maintenance Charging
NOTE: ARGO recommends the use of a battery charger/maintainer.
Maintenance charging is required on all batteries not used for more than two
weeks or as required by battery drain.
1. When charging a battery in the vehicle, be sure the ignition switch is in the “OFF”
position.
2. Clean the battery terminals with a solution of baking soda and water.
NOTE: The sealing strip should NOT be removed and NO uid should be
added.
3. Ensure the charger and battery are in a well-ventilated area and the charger is
unplugged from the 110-volt electrical outlet.
4. Connect the red terminal lead from the charger to the positive (+) terminal of the
battery; then connect the black terminal lead of the charger to the negative (-)
terminal of the battery.
5. Plug the battery charger/maintainer into a 110-volt electrical outlet.
6. Follow charging instructions supplied with the charger/maintainer.
NOTE: Not using a battery charger with the proper oat maintenance will
damage the battery if connected over extended periods.
7. Once the battery has reached full charge, unplug the charger from the 110-volt
electrical outlet.
NOTE: If, after charging, the battery does not perform to operator
expectations, bring the battery to an authorized ARGO dealer for further
troubleshooting.
TOC

Argo Xplorer XR 700 EPS 2023 Specifications

General

Brand	Argo
Model	Xplorer XR 700 EPS 2023
Category	Offroad Vehicle
Language	English