57
Pre-Operation Checks
Inspect your vehicle each time you use it to make sure the vehicle is in safe
operating condition.
Always follow the inspection and maintenance procedures and schedules described
in your Operator’s Manual.
WARNING
Failure to inspect or maintain the vehicle properly increase the possibility of an
accident or equipment damage. Do not operate the vehicle if you nd any problem. If
a problem cannot be corrected by the procedures provided in this manual, have the
vehicle inspected by the dealer.
Engine Break-In
There is never a more important period in the life of your ATV than the rst 10
hours of operation. Always use a light throttle, keeping engine RPM well below the
maximum. Varying the engine RPM during the break-in period allows the engine
and transmission components to mate together so they will operate smoothly in the
future. Applying some higher engine RPM and other loads during the break-in period
is not detrimental when done in moderation. Do not pull a trailer or haul heavy cargo
during the break-in period.
When the engine starts, allow it to warm up properly. Permit the engine to idle for
several minutes until it has reached normal operating temperature. However, do not
allow the engine to idle for excessively long periods of time, as this additional heat
can aect future engine integrity.
Before You Ride
SECTION 6
BRAKE PADS MUST BE BURNISHED TO ACHIEVE FULL BRAKING EFFECTIVENESS.
Braking distance will be greater until the brake pads are properly burnished.
To properly burnish the brakes, use the following procedure:
1. Choose an area sucient to safely accelerate to 30 mph and smoothly brake to
a stop.
2. Accelerate to 30 mph, then compress the brake levers to decelerate to 0-5 mph.
3. Repeat procedure 10 times.
4. Stop the vehicle and allow the brake pads to cool to ambient temperature.
CAUTION
WARNING
Do not attempt sudden stops or put yourself into a situation with your ATV where a
sudden stop will be required until the brake pads are properly burnished.
After the completion of the break-in period, your ATVs engine oil and lter should be
changed. Other maintenance after break-in should include checking all prescribed
adjustments and tightening all fasteners. It is your responsibility as the owner and
rider of your ATV to arrange for and pay for this initial service.
Because of the technical ability and resources available at an authorized ARGO
dealer, it is best to take your ATV to the dealer for service rather than attempting to
perform this initial service yourself.
To Next Page
Loading...
Need help?
General
