Arjo Citadel - Electricity Supply

17
Citadel Bed Frame System
Electricity Supply
If the power cord or plug is damaged, the complete assembly must be
UHSODFHGE\DXWKRUL]HGVHUYLFHSHUVRQQHO'RQRWUHPRYHWKH¿WWHG
SOXJRUXVHDUHZLUHDEOHSOXJRUDGDSWHU
0DNHVXUHWKHSRZHUFRUGLVQRWVWUHWFKHGNLQNHGRUFUXVKHG
'RQRWDOORZWKHSRZHUFRUGWRWUDLORQWKHÀRRUZKHUHLWPD\FDXVHD
WULSKD]DUG
Make sure the power cord does not become entangled with moving
SDUWVRIWKHEHGRUWUDSSHGEHWZHHQWKHEHGIUDPHDQGKHDGERDUG
Unplug the power cord from the electricity supply, and store it, before
PRYLQJWKHEHG
%HIRUHWKH¿UVWXVHRULIWKHEHGKDVEHHQXQXVHGIRUPRUHWKDQWKUHHPRQWKV
connect the bed to the electricity supply for at least 24 hours to allow the backup
battery to recharge fully; failure to do this may reduce the life of the battery. After
charging, check that the battery is fully serviceable by carrying out a battery test as
shown on page 60.
Connect the mains plug to a suitable outlet. Make sure the plug is easily accessible so
it can be unplugged quickly in an emergency.
When the bed is connected to the electricity supply, the Power On Indicator LED will
light on the Attendant Control Panel (see page 34).
7KHSRZHUVXSSO\FRUGLV¿WWHGZLWKDSODVWLFKRRN
When not in use or before moving the bed, clip the hook onto the head board, coil up
the cable and place it over the hook as shown.
)LJXUH3RZHUVXSSO\FRUGDQGSRWHQWLDOHTXDOL]DWLRQWHUPLQDO
To isolate the bed from the electricity supply, unplug the mains plug from the outlet.

