Arjo Citadel - General Recommendations; Cleaning the Citadel Bed Frame System While in Use

57
Citadel Bed Frame System
General Recommendations
The following are the Arjo recommended cleaning and infection control procedures
for the Citadel Bed Frame System while it is in use.
It is recommended that all sections of this guide be reviewed prior to product use.
Carefully read the
Risks and Precautions and Safety Information sections in the
Introduction chapter prior to performing cleaning procedures on the Citadel Bed
Frame System.
To prevent cross contamination or equipment damage, Arjo
recommends that the Citadel be cleaned during use and between
SDWLHQWVDFFRUGLQJWRWKHLQVWUXFWLRQVEHORZ/RFDOSURWRFROVDQG
UHJXODWLRQVSURFHGXUHVIRUEORRGERUQHSDWKRJHQVPD\EHXVHG
SURYLGHGWKHPDQXIDFWXUHU¶VLQVWUXFWLRQVDUHIROORZHG
Always disconnect the Citadel Bed Frame System from mains wall
RXWOHWEHIRUHFOHDQLQJ)DLOXUHWRGRVRFRXOGUHVXOWLQHTXLSPHQW
GDPDJHDQGRUHOHFWULFVKRFN
Cleaning the Citadel Bed Frame System While in Use
'RQRWDOORZÀXLGWRSHQHWUDWHWKH&LWDGHO%HG)UDPH6\VWHPFRQWURO
SDQHOV
1. If possible, remove the patient from the bed prior to cleaning. Daily care
and cleaning consists of wiping down all surfaces and side rails (as
needed) during patient bathing.
2. )ROORZFDUHDQGFOHDQLQJLQVWUXFWLRQVIRUWKHVSHFL¿FSDWLHQWVXSSRUW
surface in use.
3. Unplug the Citadel Bed Frame System from wall outlet.
4. Inspect the power cord for any signs of wear or damage. The Citadel Bed
Frame System should not be operated with a worn or damaged power
cable. Contact Arjo if damage is found.
5. Using a cloth dipped in warm soapy water or approved hospital
disinfectant (diluted according to manufacturer’s instructions), wipe the
surfaces of the Citadel Bed Frame System. Rinse with plain water and
allow to dry completely.
6. Allow all components to dry completely before returning to use.
7. Inspect all parts of the Citadel Bed Frame System for damage prior to
returning them to use. Contact Arjo as required for service or replacement.
8. Plug in bed to wall outlet and adjust settings.