41
Citadel Bed Frame System
Weighing Units
On select models, weight readings can be viewed in pounds or kilograms by pressing
the Select Units button. An indicator LED next to the display will light to show the
selected units (lb or kg), if equipped.
To lock the Select Units button so that the display always shows readings in either
pounds or kilograms, if equipped:
1. Hold down the Function Lockout button.
2. Press and hold the Select Units button. Keep both buttons pressed until you
hear an audible tone. Check that the required indicator LED is illuminated (lb
or kg), if equipped.
Normal operation of the Select Units button can be restored by repeating this
procedure.
Auto Compensation
The Auto Compensation function allows weight (up to a maximum of
100 kg [220 lb]) to be added to or removed from the bed, without affecting the
indicated patient weight.
1. With the patient lying on the bed, press the Auto Compensation
button once.
2. The display will show a moving circular pattern until a stable
weight reading is obtained.
3. The display will read AUTO to indicate that the system is in Auto
Compensation mode.
4. Add or remove accessories, bed linen, pillows, etc. as required.
5. Press the Auto Compensation button again.
6. The display will show a moving circular pattern for a few
seconds then revert to showing the patient’s weight.
To Next Page
Loading...
