ASCOM D62 Configuration Manual

TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
28
• Show and indicate incoming messages (while charging)
1

Determines how incoming messages shall be displayed/indicated when the
hands
et is placed in charger. If this parameter is set to No, the message alert (if
any) will be muted and only the New message icon will be displayed. The
messages will be stored as unread messages, in the Messaging Inbox.

NOTE: All incoming messages will be affected
by this setting; that is PTT invitation
received as message, and all other messages regardless of priority (even
messages with breakthrough such as high/alarm priority). If you only want to
silence messages without breakthrough (low/normal priority), set the Sound off
parameter instead.
5.15.2 In Charger Action when in Call
The handset can be configured to end a call, or turn
on the loudspeaker when it is placed in a
charger during a call. If the handset is removed from the charger during the call, it will not
return to previous settings.
1 Select Connections > In Charger
2In the Call be
haviour drop-down list, select one of the following:
• No action - no action will be performed when hand
set is placed in charger
• End - the handset will disconnect calls when placed in ch
arger
Note: Some systems/PBXs require that the handset sends a DT
MF tone in order to
end a call, See 5.11.1 Send DTMF Tone when Pressing On-Hook key on
page 25 for
configuration.
• Put on Loudspeaker - the handset will activate the loudspeaker mode when
placed in charger.
5.15.3 Clear Lists when inserted in Charger
The handset can be configured to clear lists when place
d in a charger. The following
message and call lists will then be cleared:
•Inbox
•Unsent
•Sent
• Call list
• Missed calls
Using the PDM and the "Edit template" featur
e, the parameter can be found at
Connections > In_Charger > Clear_Lists_In_Charger
in a template or parameter definition file (.def).
The default setting for "Clear list in charger" is "O
ff". The feature is activated by changing
the parameter value to "On". When the feature is enabled, the lists are cleared when the
handset is placed in the charger.
5.16 Disable Homebase GAP Registration
When the feature is enabled, it is not possible to register to a home base.
Using the "Edit template" feature in the PDM, the parameter can be found at
Systems > Home_Base_Subscription.
1.Applicable for d62 Messenger and d62 Protector only.

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English