TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
33
• Password protect ALS
Determines if a password is required to turn off the ALS
• Number for automatic call after alarm
Determines which number the handset automatically shall call after an alarm is se
nt. This
number call also be dialed without sending an alarm, see 5.25.1 Call Predefined Number
without Sending Alarm on
page 34.
See also 5.25 Push Button Alarm for additional parameter settings.
5.25 Push Button Alarm
Note: This feature is applicable for d62 Protector only.
It is possible to configure how alarms shall be handled in a system. An alarm can be
activa
ted by a user in two different ways:
• A single long press
• Multiple press
The following alarm types are handled:
• Push-button alarm
• Test alarm
In a template or Number in PDM/Devi
ce Manager, the parameters for activation are found
at:
Alarm > Alarm on long press
Alarm > Alarm on multiple press
Parameters in the current version are:
• Alarm type for long press
Test alarm, Push-button Alarm 1, or Push-button Ala
rm 2, or Not used. If Not used is
selected, it is still possible to dial the call after alarm number without sending an alarm,
see 5.25.1 Call Predefined Number without
Sending Alarm on page 34.
• Text indication for alarm on long press?
• Duration for long press
• Alarm type for multiple press
Test alarm, Push-button Alarm 1, or Push-button Ala
rm 2, or Not used. If Not used is
selected, it is still possible to dial the call after alarm number without sending an alarm,
see 5.25.1 Call Predefined Number without
Sending Alarm on page 34.
• Text indication for alarm on multiple press
• Define multiple press
•ALS
1,2
• Silent alarm
1
If enabled, the indication of an alarm has been sent and received is disabled.
1. If the parameters "ALS" and "Silent alarm" are set, no ALS will be triggered after an alarm has been sent.
2. The ALS will not be activated if an automatic call is established after an alarm has been sent.
To Next Page
Loading...
Need help?
General
