EasyManuals Logo

ASCOM D62 Configuration Manual

ASCOM D62
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
15
4.7.2 Handset Replacement with Device Manager in DECT System
NOTE: The handset to be installed must not have any previ
ous valid registrations. If it has a
valid registration, unsubscribe the handset.
1 Unsubscribe the old handset. If the unsubscribti
on cannot be performed in the
handset, unsubscribe the handset via the DECT interface. See the corresponding IP-
DECT documentation.
2 Subscribe the new handset with the same extension number as the old handset. The
subscription procedure is described in User Manual, Ascom d62 DECT Handset,
TD 92477GB. During the subscription procedure, the handset’s User ID will
automatically be set to be the s
am
e as the extension number.
Tip: The User ID can be viewed in the handset by navigat
ing to the menu:
Admin menu > Device info > User ID.
3 Insert the handset into a desktop charger or rack charger connected to Device
Ma
nager (not needed if an over the air connection is used). Navigate to the Numbers
tab in the Device Manager.
The new handset now has the same User ID as the
old
handset. It will automatically
be synchronized and data and parameter settings from the old handset will be
transferred to the new handset.
The synchronization will take a while if the Co
ntacts in
the original handset contains
a large number of contacts.
4.8 Handset Replacement with PDM
To see which data that is replaced during this process, see 4.7.1 Data Included in a
Replacement Transfer on pa
ge 14.
Both the old handset and the new handset must be of the same device type (d62). The
same ext
ension number is assigned to the new handset.
The new handset should not be subscribed towards the PBX yet.
1 Perform a factory reset, see 4.5 Perform a Factory Reset on page
13, if the new
handset has been previously used.
2 Make sure that the handset is saved in the PDM. In the Numbers tab, a saved handset
has the symbol
in the Saved column. If not, right-click the handset and select
"Save" in order to transfer the settings to
the new handset later on.
Note: If it is impossible to save the old handset settings, stop this replacemen
t procedure.
Instead register the new handset and follow the instructions for installing a handset, see 3.2
Installing a New Handset on pa
ge 8.
4.8.1 Handset Replacement with PDM in DECT System
NOTE: The handset to be installed must not have any previ
ous valid registrations. If it has a
valid registration, unsubscribe the handset.
1 Unsubscribe the old handset. If the unsubscribti
on cannot be performed in the
handset, unsubscribe the handset via the DECT interface. See the corresponding IP-
DECT documentation.

Table of Contents

Other manuals for ASCOM D62

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ASCOM D62 and is the answer not in the manual?

ASCOM D62 Specifications

General IconGeneral
BrandASCOM
ModelD62
CategoryHandsets
LanguageEnglish

Related product manuals