TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
37
Settings > Display
•Rotate display text
Determines if incoming messages shall be disp
layed upside down. This can be useful if
you wear the handset in a belt and want to read the message without rotating the
handset. When pressing any key, the messages will be displayed in the normal way.
Note: This setting also affects how incoming calls shall be displayed.
5.26.1 Configure Message Alerts with Beep Codes
The handset can map beep codes sent from a system
/an application to different message
alerts. There are several ways to threat the beep codes:
Beeps according to beep code
Beep code sent from a system/application The handset plays:
Beep code 0 No message alert is played
Beep codes 1- 6 1 - 5, and 10 beeps
Beep code 7 Siren
The handset will play the original m
essage alerts th
at are mapped to the beep codes.
1 Select Settings > Sound and Alert.
2In the Message alert drop-d
own list, select "Beeps according to beep code".
High beeps according to beep code
Beep code sent from a system/application The handset plays:
Beep code 0 No message alert is played
Beep codes 1- 6 1 - 5, and 10 beeps
Beep code 7 Siren
The handset will play the message alerts that are mapped
to beep codes but with a higher
tone.
1 Select Settings > Sound and Alert.
2In the Message alert drop-down list, select "High beeps according to b
eep code".
Enhanced beeps according to beep code
Beep code sent from a system/application The handset plays:
Beep code 0 No message alert is played
Beep codes 1 -3 1 - 3 beeps
Beep code 4 3 tones chime
Beep code 5 10 beeps
Beep code 6 Alarm sweep
Beep code 7 Siren
The handset will play extended
message alerts that are
mapped to the beep codes.
1 Select Settings > Sound and Alert.
To Next Page
Loading...
