TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
16
2 Subscribe the new handset with the same extension number as the old handset. The
subscription procedure is described in User Manual, Ascom d62 DECT Handset,
TD 92477GB.
During the subscription procedure, th
e handset’s User ID will automatically be set to
the same as the extension number. The User ID is used to identify the handset when
it is connected to PDM and will be visible in the Number column.
Tip: The User ID can b
e viewed by navigating to the menu:
Admin menu > Device info > User ID.
3 Insert the new handset into a desktop charger or
rack charger connected to the PDM.
4 A dialogue window appears, asking the user to
decide whether to use the Number
settings in PDM or the Number settings in the device. Select "PDM".
The handset will automatically be synchronized a
nd all data and parameter settings
will be transferred to the new handset. The synchronization will take a while if the
Contacts in the original handset contains a large number of contacts.
4.9 DECT Frequency Band Configuration
NOTE: The frequency band configuration is only needed if other frequencies than EU US
China shall be used. Additionally, if the handset has been returned from repair, the
applicable frequency band might be set again.
In order to change the operating frequency band, the following preconditions m
ust be
fulfilled:
• The frequency is set to Not initiated. This can be
checked by entering the Admin menu,
see 6 Administration on pag
e 52, follow the path:
Admin menu > Device info > Hardware.
Scroll down to “Frequency band”.
• The handset must not have a DECT registration. If it
already has, perform a Factory reset,
see 4.5 Perform a Factory Reset on
page 13.
1 Enter the Admin Menu, see 6 Administration on
page 52.
2 Select "Frequency band" and select the desired band.
• EU US China (default)
• LA (Latin America)
•Brazil
• 1900 - 1920 MHz
• Multifrequency (see also 4.9.1 Multiple Frequency Support)
3 Restart the handset.
4 Register the handset.
5 The frequency band option will no longe
r be available.
NOTE: The selection is persistent an
d will stand a factory reset.
4.9.1 Multiple Frequency Support
The handset can be used in a system that changes f
requency by selecting "Multifrequency"
as frequency band in the handset. See 4.9 DECT Frequency Band Configuration. This setting
is applicable for handsets used in different re
gions of the world. For example for users
working on a ship that visits different countries.
To Next Page
Loading...
Need help?
General
