ASCOM D62 - Call Predefined Number Without Sending Alarm; Messaging Settings

TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
34
• Mode for automatic call after alarm
The call can be established in the following m
odes;
- Normal: the call is establish
ed as an ordinary call.
- Loudspeaking: the loudspeaker on the backside of t
he handset is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen t
o an conversation.
See also 5.24 Common Alarm Settings on
page 32 for additional parameter settings.
Information about the handset’s location can also be sent along with an alarm, see 5.19
Base Station Posi
tioning on page 29 and 5.20 DECT Location on page 30.
5.25.1 Call Predefined Number without Sending Alarm
It is possible to configure the push
-button to dial the automatic call after alarm number
without sending an alarm. The following example describes how to configure the push-
button (alarm on long press). The corresponding settings can also be configured for the
push-button when it is pressed twice or more (alarm on multiple press).
Example of configuration:
1 Select Alarm > Common
2In the Number for automatic call after alarm field, ente
r the number to be dialed.
3 Select Alarm > Alarm
on long press
4In the Al
arm type for long press drop-down list, select "Not used".
5In the Mode
for automatic call after alarm drop-down list, select one of the following:
- Normal: the call is establish
ed as an ordinary call.
- Loudspeaking: the loudspeaker on the backside of t
he handset is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen t
o an conversation.
This configuration makes it possible
to long press the push-button to dial the number
without sending an alarm. However, the push-button can be configured to send an alarm by
pressing it twice (see Alarm type for multiple press in chapter 5.24 Common Alarm Settings
on page 32).
Information about the handset’s location can also be sent along with an alarm, see 5.19
Base Station Posi
tioning on page 29 and 5.20 DECT Location on page 30.
5.26 Messaging Settings
NOTE: This feature is applicable for d62 Messenger and d62 Protector only.
It is possible to configure how incoming mess
ages shall be indicated and displayed in
handset. The parameters can be found at:
Settings > Sound and Alerts
• Vibrate alert
Determines if the handset shall vibrate when receiving i
ncoming calls and messages.
• Message alert
Determines the message sound for incoming mess
ages. It is possible to select a
predefined melody (Message 1 - Message 7) or a beep code that represents a certain
sound. For more information on how to configure sounds with beep codes, see 5.26.1