EasyManuals Logo

ASCOM D62 Configuration Manual

ASCOM D62
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
35
Configure Message Alerts with Beep Codes on page 37.
Message alert during call
Determines if a message alert should be played when rece
iving a message during a call.
Message volume
Determines the message volume
for incoming messages. By default, the message
volume follows the ringer volume, but another message volume can be set with this
parameter.
Vibrator for message during call
Determines if the handset shall vibrate when receiving mess
ages during an ongoing call.
The Vibrate alert parameter must also be enabled if the handset shall vibrate when
receiving a message during the call.
Settings > Messaging
•Text size
Size of the message text when vi
ewing and writing messages.
Time to Read (TTR)
Determines if the user needs to close a m
essage manually, or if the message
automatically shall be closed when TTR expires. Regardless how a message is closed, it is
removed from the message queue and stored in the Messaging Inbox. TTR starts when a
message is displayed and keep running also when the message is placed in the
messaging queue. If a user presses any key when a message is displayed, the TTR is
reset. See also 5.26.2 Example of TTR/TTP settings on
page 38
Time to Prioritize (TTP)
Determines how long messages shall keep their pr
iority status. The TTP starts when a
message is displayed. If a user presses any when a message is displayed, the TTP is reset.
If receiving a message with higher priority than the displayed message, the message
with lower priority is placed in queue and its TTP is paused. When the TTP elapsed for a
message, it is put last in the queue. See also 5.26.2 Example of TTR/TTP settings on
page
38.
Message List representation
Can be set to text or number.
Repeat Message Indication
This parameter enables/disables message indications. It se
ts whether a message
indication shall be repeated until confirmed by the user or not. The current repetition
rate is 7 seconds. If the message itself contains a repetition, it overrides this setting.
IM (Interactive Messaging) Option Mode
This parameter is used for older applications and sets that three soft keys shall be placed
automatically, i.e. on soft keys or in an option menu (list).

Table of Contents

Other manuals for ASCOM D62

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ASCOM D62 and is the answer not in the manual?

ASCOM D62 Specifications

General IconGeneral
BrandASCOM
ModelD62
CategoryHandsets
LanguageEnglish

Related product manuals