ASCOM D62 Configuration Manual

TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
50
NOTE: When registering a handset for the first time in the PDM, the Number (User ID) will be
equal to the handset’s extension number. If another user logs on the same handset, the
Number will be unchanged. It is recommended to rename Number to, for example, Shared X
(where X is a number) to prevent number conflict if assigning several shared phone
handsets the same extension when subscribing towards the IP-DECT system. Renaming the
handset in PDM will also make it easier to find and administrate the handset in PDM.
See also the User Manual for Ascom d62 DECT H
andset for information on how to log on a
handset.
TIP: It is possible to log off a handset when it is placed in a charger, see 5.15.1 In Charger
Action when not in Call on
page 27.
5.39 Push-to-Talk (PTT) Group Call
Note: Messaging group(s) must be defined in the IMS3/Unite CM. See the Installation and
Operation Manual for the Unite module being used.
To be able to call a PTT group, its properties must also be se
t
1 Select "Push to Talk".
2 Select "PTT X" (where X represents the groups 1 to 10)
3 The following parameters can be set:
• Group number - The Messaging group number that is defined in IMS3/Unite CM.
• Display text - This text appears in the
display when the PTT group call is
connected.
• Indication - Depending on the handsets in a PTT
group, they may receive the PTT
invitation as a message.
• Conference number - The phone number to the conference
bridge (PTT server)
that is provided by the system administrator.
• Answer mode - Determines if the PTT call sh
all be automatically or manually
answered.
• Speaker mode - Determines if the PTT call
shall be answered in loudspeaker mode.
5.40 Bluetooth Data Profile
Note: This is a license dependent feature (see 4.4 Upgrade Handset by License on page 11)
and applicable for d62 Messenger with Bluetooth and d62 Protector with Bluet
ooth only.
The handset can be configured to receive data f
rom a bluetooth barcode reader and then
send the data to another destination.
See also the User Manual for the Ascom d62 DECT Handset fo
r information on how to
connect a bluetooth barcode reader.
In a template or Number in PDM/Device Man
ager, the parameters are found at:
Bluetooth Data > Configuration
The following optional parameters can be set:
• Prefix - A prefix (for example "*23*" or "Barcode
:") can be sent along with the barcode
data.
• Number - Determines where the data shall be sent.

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English