ASCOM D62 Configuration Manual

TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
57
7.3 Error Messages in PDM
The following error messages can be shown in the PDM. See also Installation and Operation
Manual, Portable Device Manager (PDM), Wind
ows Version, TD 92325EN.
Error message Probable cause Action or comment
Aborted 1) Trying to downgrade the
software of a handset tha
t
has been upgraded with a
product license and/or
functionality license.
2) The handset’s hardware
does not support the
software ver
s
ion you are
trying to downgrade to.
1) The license(s) can be
m
o
ved to an unlicensed
handset (that is d62 Talker)
using IMS3/Unite CM.
2) Use another software
vers
ion. Ask
you supplier.
Could not encrypt connection The parameter "Encryption
Requ
ired" is enabled in the
handset in combination with;
1) Unencrypted base
station
(
s); and/or,
2) Unsupported base
station(
s)
.
1) Disable the "Encryption
Required" paramet
er in
handset; and/or,
2) Enable the encryption in
the base s
t
ation(s); and/or,
Note: If Ascom’s base
station(
s)
is used, the
software version must be
3.1.x or greater.
3) Use supported base
station(
s).
Ask your supplier.
License key not accepted 1)The license key is to short/
long
2) The license key is not valid.
1)Make
sure that the license
key consists of 29 digits.
2) Generate a valid license
using the License Web.
Not allowed 1) The handset with the
shared phon
e functionality
enabled cannot be logged in
due to another handset using
the extension (that is, User).
2) The extension (User) does
not exists.
3) The password is not
correct.
1) Logout the handset using
the
extension.
2) Make sure that you
entered correct extension. If
needed, co
nta
ct the system
administrator.
3) Make sure that you have
entered correct pa
ssword. Ask
the s
ystem administrator if
you have forgot the
password.

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English