TD 92639EN
08 December 2012 / Ver. H
Configuration Manual
Ascom d62 DECT Handset
56
No System.
The handset beeps once a
min
ute with a low tone
followed by a high tone
(during max 30 minutes). If
the vibrator is enabled, it
vibrates after the last beep.
The handset is out of
coverage,
or faulty handset.
The beeps can be stopped
with the m
ute button. Then
go into range.
Note: When re-entering the
coverage
area it can take a
couple of minutes before the
handset automatically has
registered into the system.
If this does not work,
contact the system
ad
ministrator.
SERVICE NEEDED
Parameters corrupt
Note: This display message is
on
ly shown in English.
The handset is defective. Select the reset option on the
m
iddle soft key and upgrade
the handset’s software to
version 3.0.0 or greater. If
this is not available or the
problem persists send the
handset for service.
SERVICE NEEDED
Invalid IPDI
Note: This display message is
on
ly shown in English.
Easy replacement procedure
not followe
d correctly or
failure during easy
replacement procedure.
Send the handset for service.
Enter PIN code Phone lock is activated. Enter the required PIN code. If
the
PIN code has been lost,
enter a new PIN code via the
PDM/Device Manager or do a
factory reset via the PDM/
Device Manager.
Battery low, charge now The battery level is low. Charge the handset, or
repla
ce or charge the battery.
Phonebook is not available at
t
he moment.
The phonebook is not
activated or does not
respond.
Try again later or if the fault
persists do a factory reset via
the admin menu or via the
PDM/Device Manager.
Note that it may take several
m
inutes for the phonebook to
be available if there are many
entries in Contacts and/or
company phonebook.
Voice mail number not
defined
There is no Voice mail number
defined in t
he handset.
Define a Voice mail number
via the PDM/Device Manager.
To Next Page
Loading...
Need help?
General
