17. Power on the server.
18. Log into the system using the following credentials:
Username Password
admin admin
Note: If your organization changed these default credentials, check with your IT
administrator for an updated username and password.
19. (Optional) To configure the IP address and subnet mask, type ace-net-config -a
xxx.xxx.xxx.xxx -n yyy.yyy.yyy.yyy, where xxx.xxx.xxx.xxx is the IP address and
yyy.yyy.yyy.yyy is the netmask.
This configuration sets the IP address and netmask for Eth0, which you can use to access
the Remote Management System (RMS) via a browser to complete the network setup.
20. (Optional) For more network settings, type ace-net-config -h, and press Enter.
21. To activate the changes, type reboot, and press Enter.
32 Copyright © 2018 Advanced Simulation Technology inc.
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...