iv
INTRODUCTION
Thank you very much for purchasing this model WM-3014 HD LCD waveform monitor.
This manual contains the procedures to be followed to operate the WM-3014, the checkpoints and precautions to
be observed, and so on.
Improper handling may result in malfunctioning. Before using the WM-3014, please read through these
instructions to ensure that you will operate the monitor correctly.
After reading through the manual, keep it in a safe place for future reference.
SAFETY PRECAUTIONS
WARNING
Concerning the monitor
Do not subject the monitor to strong impact or throw it around. Doing so may
cause the liquid crystal to leak and/or the monitor to malfunction, rupture,
generate heat and/or cause a fire.
Do not use the monitor wherever there is a risk of ignition or explosions.
Do not place the monitor inside a microwave oven or other heating or cooking
appliance or pressure vessel. Doing so may cause heat or smoke to be generated
in the monitor, combustion and/or damage to the circuit components.
Inside the monitor are some high-voltage parts: since exposure to these parts
may result in electric shocks or burns and/or malfunctioning, refrain from
disassembling, repairing or remodeling the monitor.
If a thunderstorm should occur while the monitor is being used outdoors,
immediately turn off its power, disconnect the power cable from the main unit, and
move the monitor to a safe place.
Concerning the power cord
Always take hold of the molded part of the plug when disconnecting the power
cord.
Do not use force to bend the power cord or bunch it up for use. This may cause a
fire.
Do not place heavy objects on top of the power cord. This may damage the cord,
causing a fire or electrical shock.
To Next Page
Loading...
General