AT&T 1070 Installation Guide

62
DTAD setup (1080 only)
CALL SCREENING
Use this feature to choose whether incoming
messages can be heard over the speaker when
they are being recorded. If you turn call screening
on, you hear the incoming private message on
your telephone when a call comes in.
1. Press
[ENTER].
2. Press
[ ] or [ ] until you see DTAD SETUP.
Press [ENTER].
3. Press
[ ] or [ ] until you see CALL
SCREENING.
4. Press
[ ] or [ ] to choose ON or OFF.
5.
To move to the next feature, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
NOTE: If the Do Not Disturb (DND) feature is
active (page 15 of the 1080 user’s manual), the
call screening feature is disabled automatically.
DTAD INTERCEPT
Choose whether private incoming messages can
be intercepted by other phones. Someone at the
1080 phone that is recording the message can
always intercept the call. If DTAD intercept is on
when a caller leaves a message, someone on
another system telephone sharing the same line
can answer the call by pressing the corresponding
line key.
1. Press
[ENTER].
2. Press
[ ] or [ ] until you see DTAD SETUP.
Press [ENTER].
3. Press
[ ] or [ ] until you see DTAD INTERCEPT.
4. Press
[ ] or [ ] to choose ON or OFF.
5.
To move to MAIN MENU, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
DTAD SETUP
ON
CALL SCREENING
DTAD SETUP
ON
DTAD INTERCEPT

AT&T 1070 Specifications

General

Lines Supported	1
Speakerphone	Yes
Caller ID	Yes
Display	LCD
Intercom	Yes
Handset Locator	No
Call Waiting	Yes
Volume Control	Yes
Redial	Yes
Power Source	AC Adapter
Type	Corded