ATEQ F SERIES User Manual

Chapter 3 – Start-up and settings
UM-23100B-U User manual ATEQ F CLASS Page 29/90
4. DELETING A PROGRAM OR A PROGRAM NAME
To modify the parameters, turn the
key to the ACCES position.
Position the cursor in front of
PARAMETERS function.
Confirm with the ENTER key.
MAIN
MENU
RUN PROG.: 001
PARAMETERS
SPE CYCLE :Disabled
Position the cursor in front of the
program number or the program
name to be deleted.
PARAMETERS
Copy-Paste
Pr:001 ENGINE
Pr:002 HEAD
Confirm once to enter the program.
PARAM/P
r
001
TYPE : LEAK
WAIT A: 00.00 s
WAIT B: 00.00 s
Confirm a second time to gain access
to the delete menu. There are two
possibilities : delete the program
name or delete the whole program.
M/Pr001/TEST TYPE
Delete name
Program reset
1°) Confirm a third time.
The name of the program is deleted.
PARAMETERS
Copy-Paste
Pr:001 ----------
Pr:002 HEAD
2°) Place the cursor in front of
Program reset.
M/P
r
001/TEST
TYPE
Delete name
Program reset
Confirm with the ENTER key.
The program is then deleted.
PARAMETERS
Copy-Paste
Pr:001 ----------
Pr:002 HEAD
Note: if the operation "delete program" is done in first, then the program name is
deleted too.

ATEQ F SERIES Specifications

General

Brand	ATEQ
Model	F SERIES
Category	Security Sensors
Language	English