Model X High Speed Sublimation printer
48
5.2 Starting operation
5.2.1 Turn on the machine
(1) Before starting the machine, please confirm whether it meets the power-on requirements; if it meets the
power-on requirements, perform the following process.
(2) Click the green power button on the printer to connect the device to the power source.
Figure 5-1 Switch button
Note: The nozzle holder will automatically return to the cleaning position after pressing the power button.
Do not touch the moving nozzle holder and suction platform.
5.2.2 To check after starting
(1) Scraper: Check whether the blade and the base are clean, remove the accumulated ink on the surface and
dry dirt; and check if the blade is neat or not.
(2) Surface and surrounding of the nozzle: Check whether there is residual ink on the surface and the
periphery of the nozzle. The surface of the nozzle must be wiped with a moist non-woven fabric (it can be
wetted with cleaning liquid, deionized water and distilled water, or heated to the above liquid) 30 ° C -40 °
C effect is better), use a wet sponge rod or non-woven fabric to remove the dry ink and foreign matter
around the nozzle; at the same time check the nozzle negative pressure;
(Print the test strip to retain the sample).
(3) The whole moisturizing plate: the moisturizing plate is moistened with deionized water or pure water.
Under normal circumstances, it is changed once every 2-3 days. If the ink in the moisturizing tray is dirty, it
needs to be replaced every day.
5.2.3 Nozzle cleaning operation
(1) After the printer is turned on, the touch screen displays the boot interface as shown in Figure 5-2. Click
on the "Enter System" option to display the functional world
In the function interface, click the "nozzle cleaning" option.
To Next Page
Loading...