Model X High Speed Sublimation printer
47
Chapter 5 Basic Operations
5.1 Preparation before starting up
5.1.1 Environmental requirements
The temperature is controlled between 20
o
C and 30
o
C, and the humidity is controlled at 55% to 70%
RH.55%～70%RH。
5.1.2 Site requirements
The workplace must be clean and free of dust, smoking and fireworks are strictly prohibited; the
environment is clean and tidy.
Tip: Do not use the printer in an environment other than the recommended temperature and humidity, which
may cause serious plugging. Please turn on the air conditioner and humidifier in time to adjust the ambient
temperature and humidity.
5.1.3 Preparation before starting
(1) Open the total intake air: Start the air compressor and open the intake valve to ensure that the air
pressure is greater than 6KG.
(2) Turn on the main power: Turn on the main switch that connects the power of the machine.
5.1.4 To check before starting
1) Check hygiene: Keep the machine and the surrounding area clean and tidy.
(2) Check the environment: temperature 20 ° C ~ 30 ° C, humidity 55% ~ 70% RH.
(3) Check the gas source: discharge air and air in the air compressor, gas storage tank, and air supply pipe;
check whether the air pressure meet the requirements (0.58MPa).
(3) Check the suction platform: Make sure that there is no foreign matter on the surface of the suction
platform.
(4) Check the ink: Check the amount of ink in the main ink cartridge, add ink in time, be careful to prevent
the ink from being empty, causing the nozzle to break the ink.
Note: Please check the shelf life of the ink first, seal it for 3 months after opening, and record the date and
batch number of the ink.
(5) Check the waste ink: Check the waste ink tank and the waste ink tank of the nozzle cleaning position
and the moisturizing position without clogging, and dump the waste ink in time.
To Next Page
Loading...