Drive to an authorized Audi dealer or authorized
Audi Service Facility immediately to have the
malfunction corrected.
i§O Audi adaptive light
Applies to: vehicles with Audi adaptive light
rJJ Audi adaptive light: malfunction! See own-
er's manual
There is a malfunction in the adaptive lights . The
headlights still function.
Drive to an authorized Audi dealer or authorized
Audi Service Facility immediately to have the
malfunction corrected.
fi.D Light/rain sensor
II Automatic headlights: malfunction! See
owner's manual
II Automatic wipers: malfunction! See owner's
manual
The light/rain sensor is malfunctioning .
The low beams remain switched on at all times
for safety reasons when the light switch is in the
AUTO position. You can continue to turn the
lights on and off using the light switch. You can
still control all wiper functions that are inde-
pendent of the rain sensor.
Drive to an authorized Audi dealer or authorized
Audi Service Facility immediately to have the
malfunction corrected.
; Suspension control
Applies to: veh icles with Audi drive select
R Suspension: malfunction! You may continue
driving
There is an adaptive damper malfunction.
Drive to an authorized Audi dealer or authorized
Audi Service Facility immediately to have the
malfunction corrected.
Instruments and indicator lights
¢ Q Turn signals
If the. or B indicator light blinks , a turn sig-
nal is turned on.
If both indicator lights are blink-
ing, the emergency flashers are on.
In an indicator light blinks twice as fast as usual,
then a turn signal bulb has failed. Replace the
bulb immediately.
(di 4f. Rear safety belt
Applies to: vehicles wit h rear safety belt detection
The respective indicator light will turn on briefly
when a safety belt on the rear seats is fastened
or unfastened.
f!I-If this indicator light turns on briefly, the
safety belt on the rear seat is not fastened.
II- If this indicator light turns on briefly, the
safety belt on the rear seat was fastened .
• - If this indicator light blinks, the safety belt
was unfastened while driving . Above a certain
speed, there will also be a warning tone.
(D Tips
For additional information on safety belts, re-
fer to
~page 182.
On-Board Diagnostic
system (OBD)
Malfunction indicator lamp (MIL)
The malfunction indicator lamp (Mil) l&I in the
instrument cluster is part of the On Board Diag-
nostic System (OBD II) .
The warning/indicator light turns on when the ig-
nition is switched on and turns off once the en -
gine is started and is running in idle at a stable
speed . This indicates that the MIL is functioning
correctly.
If the light does not turn off after starting the
engine
or turns on while driving, this may indi-
cate there is a malfunction in the engine . If the
indicator turns on, the catalytic converter may be
damaged . ..,.
17
To Next Page
Loading...
