....
N
a:
CX)
....
I.Cl
U"I
N
I.Cl
....
Switching on
• Shift into reverse , or
• Press the
P,,1~ button in the center console
¢
fig. 85. A short confirmation tone sounds and
the LED in the button turns on .
Switching off
" Drive faster than 6 mph (10 km/h), or
• Press the
P,,1~ button , or
• switch the ignition
off.
Segments in the visual display
The segments in front of and behind the vehicle
(vehicles with park ing system plus*) ¢
fig. 86
help you to determine t he distance between your
vehicle and an obstacle . The red lines mark the
expected direction of travel according to the
steering angle . A white segment indicates an
identified obstacle that is outside of the vehicle's
path. Red segments show identified obstacles
that are in your vehicle's path. As your vehicle
comes closer to the obstacle, the segments move
closer to the vehicle . The collision area has been
reached when the next to last segment is dis-
played. Obstacles in the collis ion area, includ ing
those outside of the vehicle's path, are shown in
red . Do not continue driving forward or in reverse
¢ &. in General information on page 85 , ¢ 0 in
General information on page
85!
Rearview camera
Introduction
Applies to: vehicles with rearview camera
Fig. 87 Diagra m: lines to aid in pa rking
The rearview camera helps you to park or maneu-
ver using the orientation lines .
Parking systems
General information
Applies to: vehicles with rearv iew camera
Fig. 88 Area covered (!) and area not covered @ by the
rearv iew camera.
lo
~;;.------ ::·""~"'•"'°'•°""-------- o
<QoOOO
~
Fig. 89 Luggage compar t me nt lid: locat ion of t he rea r-
view came ra
The rearview camera is located above the rear li-
cense plate bracket . Make sure that the lens for
the parking system ¢
fig . 89 is not covered by de-
pos its or any other obstr uctions because th is can
impair the function of the parking system . For in-
formation on cleaning, refer to ¢
page 272 .
The rearv iew camera coverage area includes (D
¢ fig . 88. Only this area is shown in the Infotain-
ment display . Objects t hat are outs ide of this
area @ are not displayed .
The accuracy of the orientat ion lines and the blue
surfaces is reduced if the vehicle is raised or if the
Dynamic mode is activated ¢ page 82.
_&. WARNING
- Always read and follow the applicable warn-
ings¢
& in General information on
page 85.
- If the position and the insta llation angle of
the rearview camera was changed, for ex-
ample, after a collision, do not continue to
87
To Next Page
Loading...
