Opening and closing
Rolling code programming
Applies to: vehicles with garage door opener (Homelink)
On some systems, programming a rolling code is
also necessary.
Identifying a rolling code
"' Press the button in the control unit that is al-
ready programmed again and hold it down.
"'Watch the green LED
(D ¢ page 36, fig. 32. If
the green LED blinks quickly, the system (such
as a garage door) has a rolling code.
"' Program the rolling code as follows:
Activating the system motor unit
"' Locate the programming button on the system
motor unit. The exact location and color of the
button may vary depending on the system man-
ufacture r's brand .
"'Press the programming button on the system
motor unit (usually this will activate a "display"
on the motor unit). You now have approximate-
ly 30 seconds to program the button in the
contro l pane l.
Programming the button in the control
panel
"' Press the previously programmed button in the
contro l pane l for 2 seconds.
"'To complete rolling code programming, press
the button again for 2 seconds.
"' On some systems, the button might need to be
pressed a third time to end the programming
procedure.
After programming, the system should recognize
the signal and operate when the button in the
control panel is pressed . Now you may program
the other buttons as needed.
(D Tips
- The rolling code can be programmed more
quickly and more easily with the help of a
second person.
- If any difficulties occur when programming
the rolling code, it may be helpful to read
the system operating manual.
38
To Next Page
Loading...
