AudioCodes C450HD - Configuring Do Not Disturb (Dnd); Table 5-38: Do Not Disturb Parameters

400HD Series IP Phones
Administrator's Manual 104 Document #: LTRT-11973
Parameter Description
voip/advanced_auto_answer/timeout
The timeout before the call is answered (in seconds).
Range: 0 – 60 (seconds)
 5 = 5 seconds (default)

0
= immediately
voip/advanced_auto_answer/type

SIP_Header (default) = identical to the parameter
'voip/auto_answer/enabled' described above
 Manual = the phone automatically answers
incoming calls according to the timeout configured
in the 'voip/advanced_auto_answer/timeout'
parameter
voip/auto_answer_use_180/enabled=0
Determines whether or not the phone will ring before
auto answer, or if auto answer will occur immediately,
before the phone rings.
 0 Disable (default) = No ringing occurs before auto
answer; auto answer occurs immediately
 1 Enable – Ringing occurs before auto answer
Note:
• The configuration file parameter ‘voip/auto_answer/enabled’ must be set to 1 to
support the following:
√ voip/advanced_auto_answer/timeout
√ voip/advanced_auto_answer/type
√ voip/auto_answer_use_180/enabled
5.8.7 Configuring Do Not Disturb (DnD)
The Do not Disturb (DnD) feature can be configured. It can also be configured in BroadSoft's
BroadWorks (see under Appendix A.1.3).
 To configure DnD:
• Use the table as reference.
Table 5-38: Do Not Disturb Parameters
Parameter Description
voip/services/do_not_disturb/enabled Enables the DnD feature.
 0 Disable
 1 Enable (default)