AudioCodes C450HD - Configuring Keys; Configuring Function and Programmable Keys; Table 6-3: Function; Programmable Keys Parameters

400HD Series IP Phones
Administrator's Manual 130 Document #: LTRT-11973
6.2 Configuring Keys
The network administrator can configure the following keys:
 Function and Programmable Keys (see Section 6.2.1) – applies to all phones except
405HD
 Speed Dials (with a dedicated configuration file) (see Section 6.2.1.1)
 Softkeys (see Section 6.2.2) – applies to all phones
 Programmable Softkeys (see under Section 6.2.2.1)
 Navigation Keys (see Section 6.2.3) – applies to all phones
6.2.1 Configuring Function and Programmable Keys
On the 430HD phone, up to 12 Function Keys can be configured for Speed Dials and for
Multicast Paging (for configuring Multicast Paging, see Section 6.4). The 12 Function Keys
are located on the sidecar. The panes next to the LED keys are covered.
On the 440HD and 445HD phones, up to 33 Function Keys can be configured. Of these, you
can configure up to 12 as Speed Dials. When more than 12 are configured, these keys can
only be assigned as regular Speed Dials or for Multicast Paging (see Section 6.4). The 33
Speed Dials are configured on pages 1, 2 and 3 of the phone's sidecar. Users define 12
Speed Dials and then when defining the 13
th
, the 12
th
Speed Dial shows the page number
and the name in the 12
th
moves to the 13
th
.
On all three phones, six programmable keys are located adjacent to the screen. There are
three on each side.
To configure 1-6 Programmable Keys, configure n = 12-17 correspondingly.
To configure 1-12 Functional Keys, configure n = 0-11 correspondingly.
To configure 13-33 Functional Keys, configure n = 18-38 correspondingly.
On the 450HD / C450HD / HRS:
To configure 1-8 Programmable Keys, configure n = 0-7 correspondingly.
On the 450HD / C450HD phone with Expansion Module:
To configure 1-22 Functional Keys, configure n = 8-29 correspondingly.
On the 405HD phone:
To configure 1-9 Programmable Keys, configure n = 0-8 correspondingly.
Table 6-3: Function / Programmable Keys Parameters
Parameter Name Description
personal_settings/functional_key/n/key_label
Used to define a free string label allowing users
to identify the key.
personal_settings/functional_key/n/type
Choose either:

EMPTY = (default) If left as is, the key
will be disabled. [N/A to 405HD]
 SPEED_DIAL = key to help users quickly dial
numbers that are often used or hard to
remember.
 PAGING = When the Paging feature is
enabled, you can define Paging Groups (see
Section
6.4).
 SIP_ACCOUNT = Key dedicated to a specific
line. Available for a private and a shared line.
The line ID is configured with the