AudioCodes C450HD - Configuring Media Settings; Configuring Media Streaming; Table 5-24: Media Streaming Parameters

Administrator's Manual 5. Configuring VoIP Settings
Version 3.4.3 91 400HD Series IP Phones
5.5 Configuring Media Settings
Network administrators can configure media settings such as media streaming, RTP Port
Range and Payload Type, shown in the following sections.
5.5.1 Configuring Media Streaming
The network administrator can configure the Media Streaming feature. Configure the
parameters using the table below as reference.
Table 5-24: Media Streaming Parameters
Parameter Description
voip/media/rtp_mute_on_hold Mute sending RTP packets to remote in HOLD state.
 0 - Disabled. RTP packets are sent to remote end
when in HOLD state.
 1 - Enabled (default). RTP packets are not sent to
remote end when in HOLD state.
voip/media/allow_multiple_rtp
Defines whether to allow multiple RTP streamsfrom
different remote ends to be played toward the phone
in a single call.
 0 Disable (default)
 1 Enable
voip/media/ignore_rfc_2833_packets
Defines whether to ignore playing DTMF when RFC
2833 arrives from the network.
 0 Disable
 1 Enable (default)
voip/media/broken_connection_detection
If enabled an active call will be automatically
disconnected if no RTP packet is received within pre-
defined time.
 0 Disable
 1 Enable (default)
voip/media/broken_connection_timeout
If no RTP packet arrives for an active call within this
timeout (in seconds), the connection will be
considered broken and the call will be disconnected.
Default: 30.