AudioCodes C450HD - Enabling Agents to Sign in with Phone Numbers

400HD Series IP Phones
Administrator's Manual 198 Document #: LTRT-11973
Parameter Description
voip/signalling/sip/sip_outbound_proxy/addr
The IP address of the outbound proxy (for
example, audiocodes.com; i.e., the same as
that configured for the 'Proxy IP Address or
Host Name' parameter above). If this
parameter is set, all outgoing messages
(including Registration messages) are sent to
this Proxy according to the Stack behavior.
Default: 0.0.0.0
voip/signalling/sip/sip_outbound_proxy/port The port on which the outbound proxy listens.
Range: 1024 to 65535. Default: 5060.
voip/signalling/sip/redundant_proxy/mode
The call center's network administrator can
select either
 Disable -OR-
 Primary Fallback -OR-
 Simultaneous
For the dual-registration feature, select
Simultaneous; two proxies are registered
simultaneously so that at least one should be
up and running at any time, preventing the
call center from going down.
Note that when using the BroadSoft ACD in a
SIP Business Continuity deployment, this
parameter cannot be set to Simultaneous.
voip/signalling/sip/secondary_proxy/address Displayed only when Simultaneous is
selected for 'Redundant Proxy Mode' (see
previous parameter). Define the IP address of
the secondary proxy that will be up
simultaneously with the primary.
voip/signalling/sip/secondary_proxy/port Displayed only when Simultaneous is
selected for 'Redundant Proxy Mode' (see the
parameter before the previous). Define the
port of the secondary proxy that will be up
simultaneously with the primary.
A.3.2 Enabling Agents to Sign in with Phone Numbers
This feature lets the call center administrator power up all phones without setting a valid SIP
account. When an agent then wants to use their phone, they register to the network with their
phone number.
 To enable the feature using configuration file:
 Use the table as reference.
Table A-12: Enabling Agents to Sign in with Phone Numbers
Parameter Description
system/login_sk_before_signed_in
Determines whether or not to enable agents
sign in with phone numbers.
 0 Disable (default)
 1 Enable