AudioCodes C450HD - Page 87

Administrator's Manual 5. Configuring VoIP Settings
Version 3.4.3 87 400HD Series IP Phones
Parameter Description
voip/regional_settings/call_progress_ton
es/%d/frequency_a
Defines the low frequency (in Hz) of the tone.
Range:300 - 1980 Hz, in steps of 1 Hz.
Unused frequencies must be set to zero.
voip/regional_settings/call_progress_ton
es/%d/frequency_b
Defines the high frequency (in Hz) of the tone.
Range:300 - 3000 Hz, in steps of 1 Hz.
Unused frequencies must be set to zero.
voip/regional_settings/call_progress_ton
es/%d/frequency_a_level
Output level of the low frequency tone (in -dBm) in Call
Progress generation. Range: 0 - 63, where 63 is mute.
voip/regional_settings/call_progress_ton
es/%d/frequency_b_level
Output level of the low frequency tone (in -dBm) in Call
Progress generation.Range:0 - 63, where 63 is mute.
voip/regional_settings/call_progress_ton
es/2/name
Default: busy_tone
The calling party hears a busy tone
if the called party's line is busy. The busy tone complies
with international telcom standards in traditional non-
VOIP telephony systems.
voip/regional_settings/call_progress_ton
es/%d/tone_on_0
tone_on_0 to tone_on_3.
If the signal is Cadence or Burst, then this value
represents the on duration. If a Continuous tone, then
this value represents the minimum detection time. In
units of 10 msec.Range:0 - 10000.
voip/regional_settings/call_progress_ton
es/%d/tone_off_0
tone_off_0 to tone_on_3.
If the signal is Cadence, then this value represents the
off duration, in units of 10 msec. If not used, then set it
to zero. If the signal is Burst, only tone_off 0 is relevant.
It represents the off time that is required from the end of
the signal to the detection time.Range:0 - 10000.