- 67 -
◆ Warp between toothed holes of each ply
Please use the paper which toothed holes warp between each ply (causes by the warp of multi-ply
papers superposition) is less than 0.4 mm.
◆Binding hole, Clipped corner
It is not support the paper which is with binding holes and clipped corners.
◆ Rumple, crease
The paper should not have creases or rumples, especially for new paper. The first and last pages
are easy to have creases or rumples, so please do not use them.
◆
The crease, crimp, fold and upturning of the paper top and bottom
Please do not use the paper which is crease, puckered, crimp and upturning in the top and bottom.
Or it may cause low printing quality or paper jam. Especially for the new paper, if it creases from the
first few pages, please do not use it.
◆ Paper folding part
Please fold the paper based on the transverse perforation. It will affect paper feeding while the
folding part sticks up as the following figure shown, please not use it.
Toothed holes section
Warp is less than 0.4 mm
Toothed hole
Caution: 1. Do not use the paper with clipped corne
or binding hole which is not
included in the guarantee list.
2. It can not guarantee device’s capability when using or after using this kind of
paper.
Rumple
Crease
To Next Page
Loading...
