EasyManuals Logo

Austro Engine AE300 Service Manual

Default Icon
360 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #342 background imageLoading...
Page #342 background image
Maintenance Manual
E4.08.04
Issue date: 14-Dec-2015
Page: 85-90
Revision no: 26
85-70-23 Removal of the Water Pump Bearing Housing Assembly
12. Drain the coolant - refer to the applicable Aircraft Maintenance Manual.
13. Remove the coolant pipe - refer to the applicable Aircraft Maintenance Manual.
14. Remove the v-ribbed belt - refer to Chapter 85-40-11.
15. Disconnect the M6 screws [6].
16. Remove the belt pulley [5] from the water pump bearing housing assembly [2].
17. Disconnect the M6 screws [1].
18. Remove the water pump bearing housing assembly [2] and the profile gasket [3].
Discard the profile gasket. Discard the water pump bearing housing assembly in case of
leakage.
Conduct an inspection of the sealing surface of the water pump housing [4] for mechanical
damages (scratches, dents, cracks, etc.). If the sealing surface shows any damage, the
water pump housing must also be replaced – for disassembly/assembly refer to Chapter 85-
70-21 and 85-70-22.
19. Clean the sealing surface of the water pump housing.
85-70-24 Installation of the Water Pump Bearing Housing Assembly
20. Lubricate the profile gasket [3] with acid free lubrication.
Only use a new profile gasket.
21. Place the profile gasket into the designated notch of the water pump bearing housing
assembly [2].
22. Bring water pump bearing housing assembly in position.
Inspect the profile gasket for correct installation.
23. Fix the water pump bearing housing assembly with M6 screws [1] and torque the
screws across with 13 Nm.
24. Mount the belt pulley [5] on the flange of the water pump bearing housing [4] with
M6 screws [6] and torque the screws with 13 Nm.
25. Install the coolant pipe - refer to the applicable Aircraft Maintenance Manual.
26. Install the v-ribbed belt - refer to Chapter 85-40-12.
27. Fill and bleed the cooling system - refer to the applicable Aircraft Maintenance
Manual.
28. Clean the working area.
29. Perform an engine ground run according to Chapter 71-00-03.
30. After the ground run inspect coolant system for leakage.
For coolant information please refer to Chapter 05-20-17

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Austro Engine AE300 and is the answer not in the manual?

Austro Engine AE300 Specifications

General IconGeneral
BrandAustro Engine
ModelAE300
CategoryEngine
LanguageEnglish

Related product manuals