ï‚· For gearbox oil discard and refill refer to Chapter 85-10-50.
05-20-07 Gearbox Oil Filter
Check gearbox oil filter according to Chapter 85-10-30.
Replace gearbox oil filter according to Chapter 85-10-30.
05-20-08 V-Ribbed Belt
Conduct a detailed visual inspection of the V-ribbed belt.
Inspect V-Ribbed Belt for abrasion and signs of damage.
Inspect the belt pulley profiles and the tensioner for damage and dirt.
In case of dirt clean the v-ribbed belt using water only.
If one of the following damages occurs replace the v-ribbed belt:
ï‚· textile reinforcement visible between the ribs
ï‚· tapered ribs
ï‚· transverse cracks on the running surface
ï‚· dirt between the ribs
ï‚· transverse cracks in the ribs
ï‚· frayed textile reinforcement
For replace of the v-ribbed belt refer to Chapter 85-40-10.
Do not lubricate the v-ribbed belt.
05-20-09 Engine – Oil
Exchange Engine Oil according to Chapter 79-00-20 and Chapter 79-00-30.
Collect a sample of the used Engine Oil using the oil container provided with the 100 h Service Kit and
send the oil sample to oil check directly (already pre-filled out envelope)..
After Engine Oil exchange perform an engine ground run according to Chapter 71-00-03.
After the ground run inspect the oil system for leakage.
If leaks are found investigate the root cause and apply repair procedures as published within this
maintenance manual.
If necessary insert engine oil according to chapter 12-20-01
05-20-10 Engine Oil Filter
Replace Oil filter according to Chapter 79-00-70.
Use only original Austro Engine oil filter insert: E4A-52-100-802
Conduct a visual inspection of the used oil filter for contamination and metal abrasion. If unusual
contamination (metal shavings exceeding 1,5 mm; concentration of particles; clogged filter) is found,
the root cause has to be eliminated permanently (e.g. by exchange of defective component within
published repair procedures) or the engine has to be replaced.
05-20-11 High Pressure Pump
Replace High Pressure Pump according to Chapter 73-00-40.