Chapter 76-00-00 Engine Control
76-00-01 General
For detailed description refer to the Chapter 01-10-60 Electrical System Description.
76-00-10 Engine Electronic Control Unit (EECU)
For removal and installation of the EECU refer to the applicable Aircraft Maintenance Manual. In case
the EECU is replaced, an engine ground run has to be conducted (refer to section 71-00-03).
76-00-11 Software Updates
To perform an EECU Software Update you have to follow the instructions given below.
The intention of this procedure is to document the current status of the EECU, update the
EECU Software (SW) acc. to the MSB-E4-003 using the AE Wizard and document the updated
status of the EECU.
For detailed instructions on the Software Updates Process itself refer to the AE 300 Wizard User Guide
E4.08.09 revision 7 or higher.
The Software-file for updating the EECU will be part of a Flash Container (FCT) which is used by the
AE300-Wizard. This FCT is available at the Austro Engine Homepage / Client Area.
Use the appendix of MSB E4-003 “Execution Report” to document the performed update.
The EECU Software Update Procedure below will also guide you through a Software Update procedure
by use of references to AE300 Wizard.
Update EECU
Software
Acc. „AE300 SW Update
Check-Sheet“
Engine Log
EECU
updated
Flash Container
with new SW
(downloaded from
AE-Homepage)
Engine Log
AE300 Wizard
Flash Log
EECU
SW to be updated
Flash Autosave
Engine Log
Load Flash Container
into Wizard
To Next Page
Loading...
Need help?
General
