The Boost Pressure Actuator (BPA) and the BPA mounting bracket is replaced as part of the turbo
charger assembly. For removal and installation of the BPA refer to Chapter 81-00-20.
05-30-04 Cylinder head
For engine model E4P: Only use cylinder head assembly E4PA-12-R10-000 for
replacement. Ensure that no “EU5” marking is visible on the cylinder head.
For engine model E4: Use cylinder head assembly E4A-12-R10-000 for replacement.
Replace the camshafts during cylinder head replacement.
Conduct the power evaluation described in chapter 85-50-00 before the replacement of
the cylinder head.
For cylinder head replacement refer to chapter 85-50-00.
Conduct the power evaluation described in chapter 85-50-00 after the replacement of the
cylinder head.
Before determining the airworthiness Austro Engine GmbH has to check the collected
power evaluation data and confirm that no power loss has occurred.
To Next Page
Loading...
Need help?
General
