AS1635-MT-EN-03
p. 15/46
4.3.2. Information mode
The display shows bOOt at start-up, and rUn when the program has started.
The error code is displayed if the program detects a problem: The error code is E-HH or HH.
Errors beginning with 0 are major errors; Errors starting with 1 are minor errors:
MAJOR error(s)
Error code Error description:
E-00
: Position sensor disconnected or non-functional.
E-01
: Position sensor out of calibration.
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other
than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems. The
document is subject to change without notice.
To Next Page
Loading...
