AS1635-MT-EN-03
p. 18/46
• 1.2345678 million: 1,234
• 12.34 million: 12.34
In other words, if there is a dot point on the display, the counter is expressed in millions.
If there is no dot point, the display directly indicates the counter value.
Press the Left button to go back to the label of the counter.
4.3.3.4. system
With vErS on the display, the software version is displayed by briefly pressing the right button (SW4). The code has
more than 4 characters and is therefore scrolled from left to right.
The same applies for the count of the programming lines (5 or 6 digits).
vErS
: Software version
SVN
: SVN version. (Subversion number; this is a count of the modifications of the programming lines)
SAvE
: Save the parameters and counters (for example, before a power outage).
To SAvE the new settings: Press the right key once; the SAv indication appears, followed by a question mark.
Start the backup process by holding down the Right key. ---- appears briefly, and then the Run standby menu is
displayed again.
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other
than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems. The
document is subject to change without notice.
To Next Page
Loading...
