AS1635-MT-EN-03
p. 30/46
12.3. outputs
This test makes it possible to activate the selected digital outputs and relays on the circuit board in order to verify their
correct functioning.
It also allows to test the buzzer.
LEDs 23 to 29 indicate the status of the outputs and relays.
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other
than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems. The
document is subject to change without notice.
To Next Page
Loading...
