Avaya 9600 Series Configuring

DJH Reviewed:
SPOC 07/08/2011
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
12 of 51
SM6-1_CMES
3.6. Configure SIP Signaling Groups and Trunk Groups
3.6.1. Add Signaling Groups for SIP Trunks
Use the add signaling-group n command, where n is an available signaling group number to
create SIP signaling groups. In the sample configuration, trunk groups “10” and “14” and
signaling groups “10” and “14” were used for connecting to both Session Managers.
Enter the following values and use default values for remaining fields.
 Group Type: Enter “sip”.
 IMS Enabled: Enter “n”.
 Transport Method: Enter “tcp”.
 Peer Detection Enabled? Enter “y”.
 Peer Server: Use default value.
Note: default value is replaced with “SM” after SIP
trunk to Session Manager is established.
 Near-end Node Name: Enter “procr” node name from Section 3.5.
 Far-end Node Name: Enter node name for the first Session Manager
defined in Section 3.5.
 Near-end Listen Port: Verify “5060” is used.
 Far-end Listen Port: Verify “5060” is used.
 Far-end Network Region: Enter network region defined in Section 3.4.
 Far-end Domain: Enter domain name for Authoritative Domain
field defined in Section 3.4
.
 DTMF over IP: Verify “rtp-payload” is used.
Note: TCP was used in the sample configuration. However, TLS would typically be used in
production environments.
add signaling-group 10 Page 1 of 1
SIGNALING GROUP
Group Number: 10 Group Type: sip
IMS Enabled? n Transport Method: tcp
Q-SIP? n SIP Enabled LSP? n
IP Video? n
Peer Detection Enabled? y Peer Server: others
Near-end Node Name: procr Far-end Node Name: silasm3
Near-end Listen Port: 5060 Far-end Listen Port: 5060
Far-end Network Region: 1
Far-end Domain: dr.avaya.com
Bypass If IP Threshold Exceeded? n
DTMF over IP: rtp-payload Direct IP-IP Audio Connections? y
Session Establishment Timer(min): 3 IP Audio Hairpinning? n
Enable Layer 3 Test? n Direct IP-IP Early Media? n
H.323 Station Outgoing Direct Media? n Alternate Route Timer(sec): 6
Repeat this step to define a second signaling group to connect to the second Session Manager.

Avaya 9600 Series Specifications

General

Brand	Avaya
Model	9600 Series
Category	IP Phone
Language	English