Avaya 9600 Series Configuring

DJH Reviewed:
SPOC 07/08/2011
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
7 of 51
SM6-1_CMES
3. Configure Avaya Aura® Communication Manager
This section describes the steps needed to configure SIP trunks between Communication
Manager Evolution Server and both Session Managers to support calls between SIP endpoints
and other types of stations on Communication Manager. These instructions assume the Avaya
G650 Media Server is already configured on Communication Manager Evolution Server. For
information on how to administer these other aspects of Communication Manager, see
References [6] through [10] in Section 9.
This section describes the administration of Communication Manager using a System Access
Terminal (SAT). Some administration screens have been abbreviated for clarity.
The following administration steps will be described:
 Verify System Capabilities and Capacities
 Configure Trunk-to-Trunk Transfers
 Configure IP Codec Set
 Configure IP Network Region
 Configure IP Node Names and IP Addresses
 Configure SIP Signaling Groups and Trunk Groups
 Configure Route Pattern
 Administer Private Numbering Plan and Uniform Dialplan
 Administer AAR Analysis
 Configure Stations
 Verify Off-PBX-Telephone Station Mapping
After completing these steps, the save translation command should be performed.
3.1. Verify System Capacities and Licensing
This section describes the procedures to verify the correct system capacities and licensing have
been configured. If there is insufficient capacity or a required features is not available, contact an
authorized Avaya sales representative to make the appropriate changes.

Avaya 9600 Series Specifications

General

Brand	Avaya
Model	9600 Series
Category	IP Phone
Language	English