Avaya 9601 - Audio Settings

Parameter Type Default
value
Description
AUDASYS Integer 3 Specifies whether the user can set the audible
alerting to the lowest level or to zero. Assign one of
the following values:
• 0: To set the audible alerting to the lowest audible
setting.
• 1: To set the audible alerting to zero.
• 2: To set the audible alerting to the lowest audible
setting.
• 3: To set the audible alerting to zero.
PHNNUMOFSA Integer 3 Specifies the number of session appearances that
the device supports while operating in a non-Avaya
environment. The range is from 1 to 10.
ENHDIALSTAT Integer 1 Specifies the enhanced local dialing status. Assign
one of the following values:
• 0: Disables the feature.
• 1: Partially enables the feature, that is, the dialing
rules do not apply for dialing from Contacts.
• 2: Fully enables the feature, that is, the dialing
rules also apply for dialing from Contacts.
SEND_DTMF_TYPE Integer 2 Specifies whether the DTMF tones are send as in-
band or out-band. Assign one of the following values:
• 1: Send as in-band, that is, as regular audio.
• 2: Send as out-band, that is, negotiation and
transmission of DTMF occurs according to RFC
2833. If the far end does not support RFC 2833,
send as in-band DTMF tones.
INGRESS_DTMF_VOL_LEVE
L
Integer –12 Specifies the power level of the tone in dBm0 after
dropping the sign. The range is from –20 to –7.
Audio settings
Parameter
Type Default
value
Description
AGCHAND Integer 0 Specifies the status of Automatic Gain Control (AGC)
for handset. Assign one of the following values:
• 0: AGC off
• 1: AGC on
Table continues…
Deskphone interface settings parameters
August 2015 Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP Deskphones SIP 55
Comments on this document? infodev@avaya.com